Have oil pressure on your Industrial engine oil system before startup and eliminate bearing wear and engine failure.

For all Industrial, Stationary, Generator, Automotive, Boat, Tractor, Truck, Diesel, Gasoline, Engines and Motors.

You've all heard a lot of numbers thrown around, but it's pretty common knowledge that at least 50% of all engine wear occurs at start-up.

This is due to the fact that the crankshaft drives the oil pump, which pressurizes the lubrication system.

Every time the engine is started, several hundred revolutions of the crankshaft can occur prior to the oil pump pressurizing your industrial engine oil system to lubricate the bearings.

The longer your engine sits without running the dryer the start-up is. After only a few days, all the oil in the galleys and bearings has drained back into the oil pan.

With the Industrial-Prelube System installed, filtered oil is stored in the accumulator tank ready to pressurize the lubrication system BEFORE the first revolution of the crankshaft.

This completely eliminates all of the wear due to dry bearing abrasion from engine start-up without oil pressure.

As soon as the ignition key is turned on, the lubrication system will start to pressurize and within a few seconds you will see pressure registering on your engine oil gauge, giving you a fully lubricated engine start.

The accumulator tank is connected to the engine oil gallery with a Teflon-Lined Stainless Steel Braded hose where the pressure-sending unit enters the block.

While the engine is running the digital controller turn the solenoid valve off to trap the highest pressure in the accumulator tank, ready for your next startup.

The next time the key is turned on; the pressurized oil is instantly released to the engine to pressurize the lubrication system just as though the oil pump was running.

    
With 3 kit sizes to choose from, there is an Insta-Lube Kit for all Industrial and stationary engines.